INDUSTRY GUIDANCE FOR HOUSEHOLDERS ON FROZEN CONDENSATE DRAINAGE PIPES
During recent winters the UK has experienced prolonged spells of extremely cold weather – down to minus 20oC and below in many areas. This resulted in a significant increase in the number of calls to boiler manufacturers and heating engineers from householders with condensing (high efficiency) boilers where the condensate drainage pipe had frozen and become blocked with ice, causing the boiler to shut down. In the vast majority of cases such problems occur where the condensate drainage pipe is located externally to the building for some part of its length.
British Standards, Building Regulations and boiler manufacturers’ installation instructions currently allow condensate drainage pipes to be located either internally or externally, or a combination of these. These documents give guidance on how to install the condensate drainage pipes in order to reduce the possibility of freezing. However this guidance may not be sufficient to prevent freezing in extreme conditions of the type recently experienced in the UK – with widespread and prolonged very low temperatures.
|Note 1This document gives guidance for householders on what to do if a boiler condensate drainage pipe has frozen – provided they feel competent to take the actions described. If you do not feel competent to follow this guidance then you should contact your local Gas Safe registered engineer, explain the situation and arrange for them to resolve the problem. They will also be able to advise on ways to reduce the likelihood of freezing in future. Registered gas engineers in your area can be found using the postcode search facility on the Gas Safe Register website at www.gassaferegister.co.uk|
There are a number of measures, detailed below, which householders can take in order to thaw a frozen condensate drainage pipe, free the blockage and re-start the boiler themselves provided they feel competent to do so (see Note 1) –
1. Confirm that a frozen condensate drain pipe is the cause of shutdown.
It is important to confirm that a frozen condensate drainage pipe is the likely cause of the problem before taking any of the remedial actions suggested below. The condensate drainage pipe is a plastic pipe (grey in colour) connected to the bottom of your boiler.
If the following circumstances apply then it is probable that a frozen condensate drainage pipe is the cause –
- outside temperatures have been below freezing for some time.
- the condensate drainage pipe runs through the wall and outside the property for part of its length, without any increased pipe diameter, any insulation on it, or other measures to prevent freezing. There may also be a problem if the pipe runs through an enclosed but unheated area, such as a garage or loft.
- the boiler has previously been working satisfactorily.
Shutdown due to freezing and blockage of the condensate drainage pipe will usually be indicated by a “fault code” on the boiler’s digital display, although this may not specifically indicate freezing as the fault. Indication may also be given by some other alarm such as a flashing light, or by a symptom such as “gurgling” noises coming from the boiler.
Note 2 – please refer to the boiler manual for guidance on fault codes/alarms and their meaning – call us if you are unsure.
2. Locate the blockage.
It is likely that the pipe is frozen at the most exposed point external to the building or where there is some obstruction to flow. This could be at the open end of the pipe, at a bend or elbow, or where there is a dip in the pipe in which condensate can collect. The location of the blockage should be identified as closely as possible before taking further action.
3. Thaw the frozen pipe.
The pipe can be thawed by applying a hot water bottle, a microwaveable heating pack (the sort used for muscular aches and pains) or cloths soaked in warm water to the exterior of the pipe, close to the likely point of blockage. Warm water can also be poured onto the pipe from a watering can or similar container. Do not use boiling water.
Note 3: You should not attempt to thaw a condensate drain pipe if you cannot easily reach it from ground level. Be aware that any water used can quickly freeze if it falls onto pathways – causing a possible slip hazard.
4. Reset/re-start the boiler.
Once the blockage has been thawed and cleared, consult the your boiler manual (if you do not have a copy you can download it from our website by clicking here) for guidance on any action needed to “reset” the fault code/alarm and re-start the boiler.
In most cases, once the condensate drain pipe is cleared and a reset has been carried out, the boiler will re-ignite using an automatic operating sequence.
If this reset/restart does not succeed you should call in a competent engineer to assess the situation and take further action if required. Registered gas engineers in your area can be found using the postcode search facility on the Gas Safe Register website at www.gassaferegister.co.uk
5. Temporary remedial actions:
If the pipe is successfully thawed and the boiler can be re-started then the following temporary remedial actions may help prevent re-freezing if the severe weather continues.
(a) If the external pipe is not insulated as recommended, you should try to rectify this by attaching suitable water-proof and weather-proof insulation over the outside of the pipe to prevent re-freezing. “Class O” pipe insulation is suitable for external use and should be available from DIY outlets and plumbing/heating suppliers.
(b) During the cold spell it may help to temporarily run the heating system with the boiler thermostat (as distinct from the room thermostat) set to maximum. Turn back to the normal setting used once the cold spell is over.
(c) It may also help to temporarily set the central heating timer/programmer to “continuous” (24hr) mode, setting the room thermostat overnight to around 15oC. Again, return to the normal settings once the cold spell is over.
6. Longer term actions:
As previously stated, British Standards, Building Regulations etc. currently allow condensate drainage pipes to run either internally or externally, or a combination of these. These documents give recommendations on how to run the pipe and use insulation, if required, in order to reduce the possibility of freezing, This guidance was based on prevailing UK winter conditions, however it may not be sufficient to prevent freezing in extreme conditions of the type experienced over recent years.
Should you wish to take action in order to reduce the risk of freezing in future, either by relocating the condensate drainage pipe or by taking other measures, then more detailed guidance is available from your heating installer, service engineer, or on-line here
What is condensate and what does the condensate drain do?
High efficiency (condensing) boilers remove more heat from the combustion gases, resulting in additional water vapour which is collected within the boiler as condensate, and taken to a suitable drain via the condensate drainage pipe.
Why has my condensate drain only frozen recently?
Recently the UK has suffered from unusually cold weather, over prolonged periods. Existing recommendations for condensate pipe installation, such as pipe insulation, were based on prevailing UK weather conditions and may not be sufficient in the extreme conditions recently experienced across much of the UK.
Shouldn’t my condensate drainage pipe have been installed correctly in the first place?
British Standards, Building Regulations etc. currently allow condensate drainage pipes to be run internally, externally or a combination of these. These documents give recommendations on how to run the pipe and use insulation in order to reduce the possibility of freezing. This guidance was based on the UK winter conditions prevailing until very recently, however it may not have been sufficient to prevent freezing in extreme weather conditions.
Can I improve the pipe installation to prevent freezing?
It would be advisable to examine the condensate drainage pipework and upgrade the installation if required, in order to reduce the risk of freezing in future. This should be done by a competent person and in accordance with relevant British Standards and industry guidance.
A heating engineer cut the condensate pipe to get my boiler working and left the pipe discharging to a bucket as an “emergency measure”. Is this acceptable?
It is recognised that in some instances (e.g. where an elderly person’s heating needs to be reinstated as an emergency measure) frozen condensate drainage pipes may have been cut in order to bypass the blockage. This has been done to allow re-ignition of the boiler, with condensate being collected in a suitable container as a temporary solution.
While not unsafe, this is not recommended practice and if such action has been taken then the condensate drainage pipe must be reinstated as soon as possible, using the appropriate industry guidance (see above) to reduce risk of freezing in future.